Install Guides

Signal Blades

*Please use a cloth to protect any delicate surroundings close to the factory signal stalks, this will protect them from damage when using the hacksaw blade.*

1. Using a measuring device measure up 28.5mm from the base and begin to slowly cut the factory stalk using a hacksaw blade.  In my experience using just the saw blade works best due to tight spaces and ease of control.

2. Refer to the pics attached as a guide...do not start to smooth the remaining factory stalk until you are ready to fit the Signal Blades.  We want a snug fit.

3. Apply very little side to side pressure when sliding the new Blades on, you'll know when they are fully on and there should be no movement and a solid fit.

Any questions, please contact us.